Radio

OUT in Morse Code

OUT is a three-letter word. As voice-procedure language it commonly marks the end of an exchange without a reply being requested, but this page simply encodes its spelling.

--- ..- -

OUT - Character-by-Character Breakdown

What to check in OUT

U is dot-dot-dash and T is a single dash. Preserve the letter pause between them: joining the two marks at the end would hide where U stops and T begins.

Character groups for OUT. Dots and dashes stay inside each labelled group; a wider space separates words.

O---U..-T-

Compare a related message: OUT OF RANGE

Encode the exact wording below and compare it with OUT. Adding letters or words changes the signal; a word gap is longer than a letter gap. The slash in the displayed result marks that word gap and is not an extra transmitted mark.

--- ..- - / --- ..-. / .-. .- -. --. .

6.18 seconds at 20 WPM

Load OUT OF RANGE in the translator

Verify your finished pattern

Read each labelled character group in order, then decode the complete copied pattern. Check that it returns OUT, including any word spaces. In a physical layout, decorative spacers should be distinct from signal marks. The diagram illustrates grouping; it does not specify bead sizes or guarantee how a printed or permanent design will reproduce.

Keep each letter’s marks together, put a space between letters, and use / between words. Check the writing guide for accepted input and the timing reference for playback.